Design of A  Low-Voltage、Rail-to-Rail and Constant  Trans-ConductanceCMOS  Operational Amplifier

Abstract

Abstract: The principle figures of input stage middle gain stage and output stage for a usual two stage low-voltage CMOS operational amplifier and their principal performance are presented in the paper.In the input stage the parallel supplementary differential input pair structure by using NMOS tube and PMOS tube is applied in order to enable the input common mode votage range to achieve rail-to-rail.To realize the contant transconductance of input stage,the proportional current mirror technlogy is used.In the middle gain stage,the current mirror load of low voltage wide-swing cascade structure is adopted which is suitable to work in low voltage and increases output resistance,i.e.gain,and realizes rail-to-rail.In the output stage,in order to enhance the efficiency and reach rail-to-raip,it uses the push-pull common soure pole amplifier.To design a norm current source,the differential amplifier with current mirror load is applied which provides the stable bias current and bias voltage to the operational amplifier in order to guarant its stability and accuracy.For preventing op amp oscillation,the Miller compensation technology with adjusting zero resistance is adopted.The simulation by using Hspice software shows that the performance of the operational amplifier well meets the design requirement.

Key words: operational amplifier, rail-to-rail, transconductance, current mirror, supplementary differential input pair

XIE Chang-Yan, HE Yi-Gang. Design of A Low-Voltage、Rail-to-Rail and Constant Trans-ConductanceCMOS Operational Amplifier[J]. journal6, 2006, 27(5): 45-48.

References

[1] BOTMA J H.A Low-Voltage CMOS Operational Amplifier with a Rail-to-Rail Constant-gm Input Stage and a Class AB Rail to Rail Output Stage [J].Proc.ISCAS，1993,93：915-923.

[2] WU W.CS.Digital-Compatible High-Performance Operatiowal Amplifier with Rail-to-Rail Input and Output Ranges [J].IEEE Trans. on Solid-State Circuits,1994,29(1)：1 262-1 270.

[3] HOGERVORST RON,TERO JOHN P.A Compact Power-Officicent 3V CMOS Rail-to-Rail Input /Output Operational Amplifier for VLSI Cell Libraries [J].IEEE Trans. on Solid-state Circuits.1994,29(12)：1 101-1 111.

[4] DUQUE-CARRILLO J F，CARILLO J M.Input/Output Rail-to-Rail CMOS Operational Amplifier with Shaped Common-Mode Response [J].Analog Integrated Circuits and Signal Processing,2003,34(3)：844-852.

[5] 翟艳，杨银堂，朱樟明，等.一种基于SOC应用的Rail-to-Rail运算放大器IP核 [J].西安电子科技大学学报，2005，32（1）：8-12．

[6] HOGERVORST R，HUIJSING J H.Design of Low-Voltage Low-Power Operational Amplifier Cells [M].Boston:Kluwer Academic Publishers,1996.

[7] 秦世才，贾香鸾.模拟集成电子学 [M].天津：天津科技学技术出版社，1996.

[8] 刘凯，邵丙铣.一种低电压全摆幅CMOS运算放大器 [J].微电子学，2002，32（1）：23-28.

[9] 李翔生，陈殿生，秦世才，等.2.5 V/0.25 μm Rail-to-Rail 运算放大器 [J].南开大学学报，2004，37（3）：18-24.

[10] 卜登立，牛秀卿.低压下高共模输入范围恒定增益的CMOS输入级的研究 [J].南开大学学报，2002,33(2)：38-45.

[11] 朱樟明，杨银堂.一种10-ppm/℃低压CMOS常用带隙电压基准源设计 [J].电路与系统 2004，9（4）：72-78.

[12] PHILLIP E，ALLEN，DOUGLAS HOLBERG(著).冯军，李智群(译).CMOS模拟集成电路设计(第2版) [M].北京：电子工业出版社，2005.

[13] 陈贵灿，程虎，张瑞智，等.模拟COMS集成电路设计 [M].西安：西安交通大学出版社，2003.

Design of A Low-Voltage、Rail-to-Rail and Constant Trans-ConductanceCMOS Operational Amplifier

PDF (PC)

Knowledge

Abstract

Cite this article

share this article

References

Related Articles 1

Recommended Articles 0

Metrics

Comments